Midland Radio Regatta 1 Radio User Manual


 
Model RG1 Owner’s Manual
Page 5 www.midlandradio.com
Warnings
Warnings
General
This device has been tested for compliance with digital marine device limits.
These limits were created to allow for reasonable protection against damaging interfer-
ence. This device is to be used solely as an aid to navigation. Its settings may be influ-
enced by diverse factors, such as defects or malfunction of the device, environmental
conditions or improper use. It is the user's responsibility to observe reasonable pru-
dence and judgement in navigation, and as such this device should not be considered a
substitute for reasonable prudence and judgement. Do not open the radio for any rea-
son! REGATTA 1's precision mechanics and electronics require expertise and specialized
equipment; for the same reason, the radio should under no circumstances be realigned
as it has already been calibrated for maximum performance. Unauthorized opening of
the transceiver will nullify the warranty.
Radio Frequency / Installation
Midland recommends following the requirements for prevention of radio frequen-
cy exposure. Unauthorized changes or modifications to this device may invalidate con-
formity to the FCC Regulations. All changes or modifications must be approved in writ-
ing by MIDLAND RADIO CORPORATION.
This VHF DSC transceiver generates and irradiates electromagnetic energy (EME) at
radio frequency (RF), and as such must be installed and placed in operating conditions
that are in conformity with the instructions contained in this manual and with current
regulations. Not following these instructions can cause personal injury and/or malfunc-
tion of the device.
•Do not use REGATTA 1 before connecting a suitable antenna that is in perfect
working condition - although REGATTA 1 is protected, this may seriously damage
the stages of transmission power.
•Do not use transmit before ensuring proper connection of the antenna. During
transmission, remain at a minimum distance of 3 feet from the antenna.
Environmental
•Pay attention to ambient conditions - although REGATTA 1 is designed to oper-
ate under the most severe conditions, it is important to avoid exposure to envi-
ronments that are excessively humid or dusty, or to temperatures outside the
-20°C to +50°C range. Also avoid exposure to direct sunlight.
•Avoid jarring and excessive vibration - REGATTA 1 is built to resist mechanical
shock and vibration as long as these are within the norm for any electrical
device.
•Do not use this device in potentially explosive environments. A single spark may
cause an explosion.