Filter
Top Products
CHAPTER 4: MOUNTING HMS-10 LOUDSPEAKERS
14
To mount the HMS-10 with the fixed mount bracket:
1. Disassemble the fixed bracket by removing the two bot-
tom screws. Separate the wall plate from the loud-
speaker plate (labeled “Monitor”). Leave the loudspeaker
plate attached to the HMS-10.
2. Choose one of the following mounting options:
■ To mount the HMS-10 on a wall with a wood stud:
– Locate the wall stud and mark two holes on the wall
using the wall plate’s center holes as a guide.
– Drill two 1/8” pilot holes, 2.0 inches deep, at the
marked locations.
– Secure the wall plate to the wall with the two wood
screws.
■ To mount the HMS-10 on a concrete wall:
– Mark two mounting holes on the wall using the wall
plate’s center holes as a guide.
– Drill two 5/16” pilot holes, 2.5 inches deep, at the
marked locations.
– Install the wall anchors in the pilot holes so they are
flush with the wall surface.
– Secure the wall plate to the wall with the wood
screws.
3. Hang the HMS-10 on the wall by carefully sliding the
loudspeaker plate (attached to the HMS-10) down into
the wall plate’s grooves.
4. For additional stability, secure the loudspeaker plate to
the wall plate with the two bottoms screws previously
removed.
NOTE: When mounting the HMS-10 in a soffit,
allow at least 3 inches above the unit for the
mounting bracket to slide into place. The extra space
also provides the necessary ventilation for the
HMS-10’s amplifier and heat sink.
Mounting holes