Filter
Top Products
PAGE 18
REAR PANEL CONTROLS & CONNECTIONS: (Continued)
SLAVE
TO POWER AMP
CH2 CH1
REVERB
4 OHM
SLAVE:
This jack captures a signal directly from the speaker jacks and is “padded” to provide a way to use the entire sound ( pre-
amp & power stage ) and send it on to other power amplifiers. This enables you to use your Nomad as the master amp in a large venue
rig where multiple amps are used for increased coverage. It also can be used to send a signal on to amp switchers or effects processors.
NOTE: Unless SPKR MUTE is selected a load of some kind must be used at all times
to prevent damage to the amplifier.
Your warranty does not cover damage inflicted from use of
the amplifier without a load. If a speaker is not possible - use a 4 or 8 ohm resistor of at least a 50 watt
rating. A speaker would be the preferred load as it will react dynamically as it changes in impedence
according to frequency.
NOTE: The Slave level is determined by the setting of both Channel MASTERS and the OUTPUT
/ SOLO Controls. If an optimum level is not possible due to either extreme or very low performance
levels - you may call us and we will send you a diagram of how to modify the Slave level ratio to your
individual needs. Before you do this try it with all the possible ways you may need it in case it is only
one scenario that is compromising. We selected this ratio for normal performance applications and
it should be adequate for most situations.