Filter
Top Products
9
OPERATING INSTRUCTIONS (CONTINUED)
Press the POWER button to turn
the unit on; the Standby indicator
will go out.
1
1
Press the POWER button to turn
the unit off; the Standby indicator
will light.
1
7
MANUAL TUNING: Repeatedly
press the Tune/Skip/Search n 1
or o 2 button to manually
advance the frequency in the
display up or down until the
desired frequency appears.
1
2
4
Press the STOP (■)/BAND button
to select AM or FM.
NOTE: If you select the FM band,
be sure to extend the FM Wire
Antenna.
1
3
Press the FUNCTION button to
select the Tuner mode; the AM or
FM frequency will appear in the
display.
1
2
AUTOMATIC TUNING: Press
and hold the Tune/Skip/Search n
1 or o 2 button until the
frequency in the display starts to
scan, and then release the button;
the tuner will search and then
stop on the next strong station it
finds. Repeat this step until the
desired frequency appears in the
display.
1
2
5
Adjust the PRESET EQ button ❶
and VOLUME control ❷ as
desired.
NOTE: If the FM band is selected
and you have tuned to an FM
Stereo station, “STEREO” will
light in the display.
2
1
6
Hints for Better Reception
AM–The AM ferrite bar antenna is located inside the unit. It may be
necessary to turn the unit slightly so that the internal antenna is
pointing in the direction of the AM transmitter. You may have to
experiment to find the position that provides the strongest reception
for each of your favorite AM stations.
FM–Extend the FM wire antenna for best FM reception.
NOTE: When you turn the unit off and then back on again, the volume
setting will remain at the level it was when the unit was turned off.
LISTENING TO THE RADIO