Filter
Top Products
11
How to use the Remote Control
How to use the Remote Control
The supplied Remote Control is capable of directly con-
trolling the functions of contemporary McIntosh Source
Components connected to the MA6600 via the Data Ports.
Input Source Selection
Press the appropriate Source Push-button to select the
desired program source.
Mute
Press the MUTE Push-button to mute the audio in all
outputs except the REC OUTPUT. The MUTE LED above
the push-button will flash on and off to indicate that Mute
is active. To un-mute the audio, press the MUTE Push-but
-
ton again. The mute push-button is also used to activate
the special Headphone Mute Mode, refer to page 19 for
additional information.
Mono
Press the MONO Push-button to switch from Stereo to
Mono for Monophonic listening.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre
-
sets, tracks on discs or selections on a Music Server.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc
Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel Up
or
Down Push-button to seek the next available station.
Press and hold a Channel Up or Down Push-button to
seek continuously from station to station.
Note: When an external McIntosh Tuner is connected to the
MA6600, press +10 Push-button to start the automatic
brief audition of each of the presets stored in the tuner
memory. Press +10 Push-button a second time to stop
on a station preset and exit the review process.
Volume
Press the Up or Down VOLUME Push-button to raise
or lower the listening volume level.
Note: The Record Signals present at REC OUTPUTS are not
affected by volume changes.
Pause
Press the Pause Pushbutton to perform various functions
on a variety of McIntosh Components. It will also pause
the playing of a disc or tape player.
Trim
Press the TRIM Push-button until the desire Trim func
-
tion (Bass, Balance, Trim Level, Treble, etc.) appears on
the Front Panel Information display, then press the LEVEL
Up or Down Push-button to adjust the Trim setting.
Press and release the LEVEL Up or Down Push-
button to recall the last Trim Function Selected and its
current setting, additional pressing of the push-buttons will
allow adjustment of the Trim Setting.
Note: For additional information on the Trim Functions refer
to pages 16, 17 and 18.
Acc On/Off
Press ACC ON to turn the power ON or ACC OFF switch-
es AC Power ON or OFF to certain McIntosh Components
when connected via the Data Port and any McIntosh Com-
ponents connected to the ACC Power Control Jack.
Amplifier Selection
Press the 2nd Push-button followed by the OUTPUT 1
or 2 Push-buttons either separately or together, to control
the rear panel OUTPUTS 1, 2 which can feed signals to a
Power Amplifier or other accessory component.