Filter
Top Products
13
Setup, con’t
Power Control Triggers
The SPKR1(A) and SPKR2(B) Power Control Outputs are
reassignable to activate only when a given Input is select-
ed. In the following example, the Power Control SPKR1(A)
Jack will be set to function as TRIGGER A for the DVD
Input.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Press the Menu Menu or Menu Push-button until
“TRIG TUN > - - ” appears on the Front Panel Alpha-
numeric Display.
3. Rotate the INPUT Control until the display indicates
“TRIG DVD > - - ”. Refer to figure 7.
4. Press the SELECT or Push-button until the dis-
play indicates “TRIG DVD > A ”. Refer to figure 8.
5. Press the SETUP Push-button to exit the Setup Mode.
The C220 remembers for each input if the TONE BYPASS
has been activated. To de-activate the AUTOTONE fea-
ture, perform the following:
1. Press the SETUP Push-button to access the Setup
Mode.
2. Press the Menu or Menu Push-button until
“AUTOTONE ON” appears on the Front Panel Alpha-
numeric Display.
3. Press the SELECT or Push-button until the dis-
play indicates “AUTOTONE OFF”.
4. Press the SETUP Push-button to exit the Setup Mode.
Auto Tone
Remote Control Selection
The C220 will respond to Remote Control Codes NORMal
(default) or ALTernate. The ALTernate Codes are for use
when the C220 is part of a system with another McIntosh
Control Center or Preamplifier. This will prevent the Re-
mote Control from affecting the operation of both units at
the same time.
Note: If the ALT Remote Control Code is selected, the C220
will not respond using the supplied McIntosh Remote
Control. See your McIntosh Dealer for additional
information.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Press the Menu or Menu Push-button until “RE-
MOTE NORM” appears on the Front Panel Alphanu-
meric Display.
3. Press the SELECT or Push-button Push-button
until the display indicates “REMOTE ALT”.
4. Press the SETUP Push-button to exit the Setup Mode.
Figure 8
Figure 7
Accessory Power Control
The ACC (C) Power Control Output is reassignable from
going ON/OFF with the C220 (Main), to be controlled by
the Remote Control ACC ON/OFF Push-buttons. To reas-
sign it perform the following:
1. Press the SETUP Push-button to access the Setup
Mode.
2. Press the Menu or Menu Push-button until “ACC
< C > MAIN” appears on the Front Panel Alphanu-
meric Display.
3. Press the SELECT or Push-button until the dis-
play indicates “ACC< C > ON”. Refer to figure 9.
4. Press the SETUP Push-button to exit the Setup Mode.
Tube LED
To swich Off the Tube LED green illumination perform the
following:
1. Press the SETUP Push-button to access the Setup
Mode.
2. Press the Menu or Menu Push-button until
“TUBE LED ON” appears on the Front Panel Alphanu-
meric Display.
3. Press the SELECT or Push-button until the dis-
play indicates “TUBE LED OFF”.
4. Press the SETUP Push-button to exit the Setup Mode.
3. Press the TRIM LEVEL Down
Push-button until the
Front Panel Alphanumeric Display indicates “Display
3”.
4. Press the SETUP Push-button to exit the Setup Mode.
Figure 9