Filter
Top Products
18 Frequently Asked Questions
FREQUENTLY ASKED QUESTIONS
How do I clean my speakers?
Just use a dust free cloth or a soft brush to remove the dust
from your speakers. We recommend a specialty cloth
(available at the Xtatic shop at www.martinlogan.com)
that cleans your speakers better than anything else we
have tried. Do not spray any kind of cleaning agent
on or in close proximity to the electrostatic element.
What is the advantage of ESL?
Since the diaphragm is uniformly driven over its entire
surface—unlike a tweeter that is only driven at its edges—
it is the only technology that can be made large enough to
play bass, yet is still light enough for high frequencies. This
unique property allows for the elimination of high fre-
quency crossover points and their associated distortions.
What size amplifier should I use?
We recommend an amplifier with 100 to 200 watts per
channel for most applications. Probably less would be
adequate for our smaller hybrids or when used in
home theater where a subwoofer is employed. Our
hybrid designs will perform well with either a tube or
transistorized amplifier, and will reveal the sonic char-
acter of either type. However, it is important that the
amplifier be stable operating into varying impedance
loads: a stable amplifier will be able to deliver twice its
rated wattage into 4 Ohms and should again double
into 2 Ohms.
Could you suggest a list of suitable electronics and
cables that would be ideal for MartinLogan speakers?
The area of electronics and cable choice is probably
the most common type of question that we receive. It
is also the most subjective. We have repeatedly found
that brands that work well in one setup will drive some-
one else nuts in another. We use many brands with
great success. Again, we have no favorites; we use elec-
tronics and cables quite interchangeably. We would
suggest listening to a number of brands—and above all
else—trust your ears. Dealers are always the best
source for information when purchasing additional
audio equipment.
Is there likely to be any interaction between my speakers
and the television in my Audio/Video system?
Actually, there is less interaction between a television
and an electrostatic speaker than between a television
and a conventional system. However, we do recom-
mend that you keep your speakers at least one foot
away from the television because of the dynamic woofer
they employ. In the case of our center channel speakers,
however, they are fully shielded and can go anywhere.
Will my electric bill go ‘sky high’ by leaving my speakers
plugged in all the time?
No. A pair of MartinLogans will draw about 5 watts max-
imum. There is circuitry to turn off the static charge when
not in use; however, actual consumption will remain close
to the same. The primary purpose of the sensing circuitry
is to prevent dust collection on the electrostatic element.
If the diaphragm is punctured with a pencil or similar
item, how extensive would the damage to the speaker be?
Our research department has literally punctured hundreds
of holes in a diaphragm, neither affecting the quality of
the sound nor causing the diaphragm to rip. However,
you will be able to see the actual puncture and it can
be a physical nuisance. If this is the case, replacing the
electrostatic transducer will be the only solution.
Will exposure to sunlight affect the life or performance
of my speakers?
We recommend that you not place any loudspeaker in
direct sunlight. The ultraviolet (UV) rays from the sun can
cause deterioration of grill cloth, speaker cones, etc. Small
exposures to UV will not cause a problem. In general,
the filtering of UV rays through glass will greatly reduce
the negative effects on the electrostatic membrane itself.
Frequently Asked Questions