Filter
Top Products
Level Knob
Setting the level too high will cause the bass to seem bloat-
ed and is the single most common cause of bad sounding
subwoofers. A rule of thumb is that the subwoofer should
not draw attention to itself, but should simply make the sys-
tems low end seem more extended and accurate.
Low Pass Filter Knob
When the Dynamo 300 is connected in multi-channel
mode (via its LFE input), the low pass filter is not active
and your processor handles the bass management. When
connected in 2-channel mode via its line level left/right
input, the low-pass filter is active.
As a general rule the low pass filter should be set equal
to approximately 70% of your speaker’s lowest frequency
response. Remember, this is a general rule. We advise
that once you try the recommended setting using the for-
mula above, you should try the surrounding settings to see
which sounds best.
Phase Control Switch
The phase control is entirely dependent on the size and
configuration of your listening environment, the placement
of the unit, and your seating arrangement. Due to the way
bass sound waves develop in different rooms, there is
no rule of thumb for setting phase. For instance, if your
room has a peak at the subwoofer crossover area, you
may wish to set the phase so the actual acoustic outputs
of the subwoofer and main speakers are out of phase.
Experiment, try different settings and be patient.
Status LED
When the status LED (located on the front bottom of the
subwoofer) is blue, the subwoofer is on. When the status
LED is off the subwoofer is in standby mode.
Power
The Master Power switch must be set to 'Auto' or 'On'
for the subwoofer to operate. When set to 'Auto' the
subwoofer will automatically enter a power saving mode
when no audio signal is detected. The subwoofer will
automatically come out of power saving mode when a
signal is detected.
aBout the Controls
About the Controls 5
Figure 1. Dynamo 300 controls.