Filter
Top Products
5
Nº53 Power Amplifier
Installation Considerations
The Nº53 Reference power amplifier requires special care during
installation to ensure optimal performance. Pay particular attention
to instructions included in this section and to precautions included
throughout this owner’s manual.
Unpacking DO save all packing materials for possible future shipping needs.
DO inspect the Nº53 for signs of damage during shipment. If
damage is discovered, contact your authorized Mark Levinson
dealer for assistance in making appropriate claims.
DO use the built-in handles located at the top of the chassis to lift
and move the amplifier.
DO locate and remove the accessory bag from the carton. Make
sure it contains all of the items listed in the “What’s in the Box”
table on the previous page. If not, contact your authorized Mark
Levinson dealer.
Caution! DO NOT attempt to lift or move the N
o
53 power amplifier
without adequate assistance. The shipping weight of the N
o
53
exceeds what a single person should lift alone. To avoid injury or
damage to the N
o
53, at least two people are required to lift or
move the amplifier.
Two pairs of heavy white gloves, with special gripping surfaces
on the palms and fingers, are included with the N
o
53. Wear these
gloves when lifting or moving the amplifier.
Placement and
Ventilation
DO install the Nº53 Reference amplifier in a location providing it
with proper ventilation. The Nº53 is designed for placement on the
floor, but can also be installed side-by-side in a rack.
DO install the Nº53 chassis on a solid, flat, level surface.
DO install the Nº53 power amplifier close to associated
components to keep interconnecting cables as short as possible.
DO select a dry, well-ventilated location out of direct sunlight.
DO allow at least 3 to 4 inches (8 to 10cm) of clearance above and
on each side of the amplifier for proper heat dissipation.