Filter
Top Products
27
ENGLISH
HOW TO USE AND SET FEATURES
HOW TO SET ID NUMBERS
If using this unit by itself as a stereo amplifier, set the ID number
to “0” (Default setting is “0”).
Note:
If the ID number is set to a number other than “0”, this unit
cannot be used for standalone operation.
The ID number of the unit appears on the display for about 3
seconds after the power is activated.
When multiple SC-11S1s are connected, a unique ID number
must be set of each one in order to distinguish between
them.
The unit that centrally controls the other units takes ID 1.
The unit with ID1 is called the “Master”. The other units that
synchronize with the master are called “slaves” and take IDs
“2” ~ “4”.
DISPLAY button
INPUT SELECTOR
Knob
POWER ON/OFF Switch
INPUT
INPUT
SELECTOR
SELECTOR
DISPLAY
DISPLAY
ATT.
ATT.
PRE OUT
PRE OUT
VOLUME
VOLUME
PHONO
PHONO
MC
MC
TONE
TONE
PHONES
PHONES
OUT
OUT
PHONES
PHONES
POWER ON/OFF
POWER ON/ OFF
OPERATE
OPERATE
Set ID numbers as follows.
1. While pressing and holding the DISPLAY button, press the
POWER ON/OFF switch.
2. Turn the INPUT SELECTOR knob to the desired ID
number.
After finishing setting the ID number, turn power to the unit
OFF.
The setting is stored in memory and becomes active the next
time power to the unit is switched ON.