Filter
Top Products
25
ENGLISH
HOW TO USE AND SET FEATURES
REMOTE POWER CONTROL
By connecting this unit to a Marantz SM-11S1 stereo power
amplifier by remote power control, the power supply of the
SM-11S1 can be automatically switched ON/OFF in sync with
this unit’s power ON/OFF control. There are 2 trigger output
terminals on this unit, and a maximum of 2 SM-11S1s can be
controlled in sync with this unit’s power ON/OFF control.
1. Prepare the correct number of double-ended mini plug
audio connection cables for the number of SM-11S1s to
be connected. Either of the following types of connection
cables are adequate.
¶ Monaural miniplug monaural miniplug connecting
cable
¶ Stereo miniplug stereo miniplug connecting cable
Note:
Do not use connecting cables that contain resistance.
2. After completing the connections shown below, switch the
remote power control ON/OFF switch on the rear panel of
the SM-11S1 to ON.
3. Press the SM-11S1 POWER ON/OFF switch to switch to
standby mode.
4. In this condition, press the POWER ON/OFF switch on
this unit, and the power of the SM-11S1 will switch ON in
sync.
Notes:
• The SM-11S1 cannot be controlled if the SM-11S1
remote power control switch is OFF.
• When the power for this unit is switched ON or OFF,
control sync signals are output from TRIGGER OUT 1
and 2.
(However, the TRIGGER OUT 2 power ON control
signal is output approximately 1 second after the
TRIGGER OUT 1 power On control signal output.) )
AC IN
REMOTE POWER CONTROL
TRIGGER OUT
12
AC IN
ON
OFF
TRIGGER IN
REMOTE POWER CONTROL
AC IN
ON
OFF
TRIGGER IN
REMOTE POWER CONTROL
REMOTE POWER CONTROL
TRIGGER OUT
12
ON
OFF
TRIGGER IN
REMOTE POWER CONTROL
ON
OFF
TRIGGER IN
REMOTE POWER CONTROL
SC-11S1
SM-11S1
SM-11S1
Set to ON
Set to ON