Filter
Top Products
21
ENGLISH
HOW TO USE AND SET FEATURES
ATT. (ATTENUATION)
ATT. button
INPUT
INPUT
SELECTOR
SELECTOR
DISPLAY
DISPLAY
ATT.
ATT.
PRE OUT
PRE OUT
VOLUME
VOLUME
PHONO
PHONO
MC
MC
TONE
TONE
PHONES
PHONES
OUT
OUT
PHONES
PHONES
POWER ON/OFF
POWER ON/ OFF
OPERATE
OPERATE
ATT is a one-touch feature for reducing the volume level. When
the ATT button on either the unit or remote controller is pressed,
the volume level is attenuated.
1. When the ATT button on either the unit or the remote
controller is pressed, “ATT” flashes on the display and the
volume level is reduced.
When the ATT button is pressed again or the volume
is increased/decreased using the controls, the mode is
canceled and the original volume level is restored.
2. When the ATT button is pressed with the volume level at
-∞(muted), the display will change as it is shown below
appears for about 3 seconds, and attenuation is not
applied.
7 How to Set Attenuation Level
Attenuation level can only be set using the ATT button on the
unit. The attenuation level can be set at –20dB, -40dB, or -∞.
The factory default setting is -20dB.
1. Press and hold the ATT button on the unit for 2 seconds or
longer. The attenuation level will appear on the display.
2. The attenuation level setting value changes with each press
of the ATT button on the unit.
3. When the desired attenuation level setting appears on the
display, leave it unchanged for 2 seconds or longer to enter
the setting. Once entered, the display returns to the volume
level indication.
SUBSONIC FILTER
TONE button
INPUT
INPUT
SELECTOR
SELECTOR
DISPLAY
DISPLAY
ATT.
ATT.
PRE OUT
PRE OUT
VOLUME
VOLUME
PHONO
PHONO
MC
MC
TONE
TONE
PHONES
PHONES
OUT
OUT
PHONES
PHONES
POWER ON/OFF
POWER ON/ OFF
OPERATE
OPERATE
If a warped analog record or disc recorded with super-low bass
is played, the speaker diaphragm may vibrate unusually and
the disc may not be played correctly.
In such cases, the subsonic filter can be set to block the
super-low bass output component. Press the TONE button for
2 seconds or more to set the subsonic filter ON/OFF.
When the subsonic filter is switched from ON to OFF, the ON/
OFF condition of the subsonic filter is displayed for 3 seconds,
as shown below.
After displaying the ON/OFF condition, the display returns to
the volume display.
Display before
pressing the
TONE button
Press the TONE
button for 2
seconds or longer
Display after 3
seconds have
passed
Set to ON Set to OFF