Filter
Top Products
22
ENGLISH
ON SCREEN DISPLAY
INFOMATION
The on-screen display, which can be activated by the Main unit or
remote, appears on the TV screen to show the current setting status of
the SR5300.
1. GENERAL INFORMATION
When the OSD button ¤2 is pressed, the current setting are displayed
on the TV monitor.
This display disappears automatically in about 5 seconds after the
button is pressed.
q
VIDEO SOURCE:
Displays the current video source being selected with the function selector
TV, DVD, VCR1, DSS or AUX.
w
AUDIO SOURCE:
Displays the current audio source being selected with the function selector
FM, AM, CD, TAPE, CD-R, TV, DVD, VCR1, DSS or AUX.
e
DIGITAL INPUT:
Displays the digital input that you are using
DIG-1, DIG-2, DIG-3 or DIG-4.
r
SURROUND MODE:
Displays the current surround mode
AUTO, DOLBY D, DOLBY D EX, PLII MOVIE, PLII MUSIC, PRO
LOGIC, DTS, DTS ES, NEO6 CINEMA, NEO6 MUSIC, MULTI CH.
ST, CS2 CINEMA, CS2 MUSIC, CS2 MONO, VIRTUAL, MOVIE,
HALL, STADIUM, MATRIX, STEREO
Note:
• Not all modes will be present depend on selected input.
t
MASTER VOLUME
Displays the current volume level.
The volume level is higher at the right of the display.
Notes:
• The On-Screen Display signals can be output from the TV
MONI composite video (RCA) output and the TV MONI S-
Video output jacks.
• When you connect both the composite video and S-VIDEO,
there will be no signal output from composite video jack.
• With some video equipment or software, the On-Screen Display
characters may be distorted due to noise or tracking adjustment
error.
2. FUCTION SELECT & SURROUND MODE
When a function selector button or surround mode button is pressed
VIDEO: Displays the current video source. When TV,DSS,
DVD, VCR1 or AUX is selected with the function
selector, both AUDIO and VIDEO shows the same
name.
AUDIO: Displays the current analog audio input source.
DIGITAL: Displays the current digital input source.
SURR-MODE: Displays the current Surround mode.
3. MASTER VOLUME CONTROL
Displayed when the MASTER volume is varied or a button of the
remote control unit is pressed.
4. MUTE
When the MUTE button !1/b is pressed, “MUTE ON” will be shown on
screen.
Pressing MUTE button !1/b again will show “MUTE OFF” on screen,
and return to the previous volume level.
5.SLEEP TIMER
When the SLEEP button o / ¤3 is pressed, the setting on or off and
the remaining time of the sleep timer function are displayed.
You can change the mode between on, off and the amount of time to
elapse before the unit will shut itself off by cycling the SLEEP button o/¤3.