Filter
Top Products
9
ENGLISH
CONNECTION OF SPEAKER SYSTEMS
This unit is equipped with two sets of SPEAKER SYSTEM terminals––SYSTEM 1 terminals and SYSTEM
2 terminals. Usually connect your speaker system to the SYSTEM 1 terminals.
• The speakers in the speaker system should have an impedance between 8 and 16 ohms. If speakers with
an impedance of less than 8 ohms are connected, the protection circuitry may be activated during play.
• Connect the Right channel speaker to the R terminals, and the Left channel speaker to the L terminals.
• The output terminals have positive (+: Red) and negative
(–: Black) polarity, and each speaker also has the same polarity (+ and –). When connecting the speaker,
be sure to connect the terminals with the same polarity (+ with +, – with –).
SYSTEM2
SYSTEM2
SYSTEM 1 : 4
SYSTEM 1 : 4
–16 OHMS
–16 OHMS
SYSTEM 2 : 4
SYSTEM 2 : 4
–16 OHMS
–16 OHMS
SYSTEM 1
SYSTEM 1
+
2 : 8
2 : 8
–16 OHMS
–16 OHMS
SYSTEM1
SYSTEM1
R L
R L
PHONO
PHONO
GND
GND
L
R
L
R
OUT
OUT
IN
IN
OUT
OUT
IN
IN
SPEAKER SYSTEMS
SPEAKER SYSTEMS
(
CD-R
CD-R
)(
MD
MD
/
TAP E
TAPE
)
AUX
AUX
/
DVD
DVD
CD
CD
TUNER
TUNER
RECORDER 1
RECORDER 1
RECORDER 2
RECORDER 2
CONNECTIONS
WIRING SPEAKER CABLE
• Be careful not to short circuit in wiring speaker
cables.
• Peel off the corting of speaker cable as shown
below.
Approx. 1 cm
Cut the corting of
cable.
Peel off the edge
of cable.
Twist conductors.
• Wiring with speaker cable.
Turn counter-
clockwise to
loosen.
Insert conductor
of cable.
Turn clockwise to
tighten.
Your speaker system must satisfy the below
conditions. If it does not, the PM6002’s protective
circuit will active, whereby preventing proper
playback. In some cases, the amplifier and speakers
may be damaged.
• If using 1 set of speakers, total speaker
impedance must be 4 ohms or more.
• If using 2 sets of speakers, total speaker
impedance must be 8 ohms or more.