Filter
Top Products
6
ENGLISH
NAMES AND FUNCTIONS OF PARTS
REMOTE CONTROLLER
Using this remote controller, you can control the
PM6002 and Marantz CD players, DVD players,
tuners, tape decks etc. that have a remote control
receptor. The operations possible by remote
controller may differ with each component; therefore
see the instruction manual that came with the
component.
The remote controller buttons are laid out as shown
below.
z POWER ON/STANDBY buttons
a. MAIN POWER ON button
Turns the PM6002 power on when it is in the
standby mode.
b. MAIN POWER STANDBY button
Sets the PM6002 power to the standby
mode when it is set to the power-on mode.
c. SOURCE POWER button
Switching the mode of a CD player, tuner,
CD-R or other Marantz component equipped
with a power standby function between
power-on and standby is enabled by pressing
this button after the FUNCTION SELECT
button corresponding to the component has
been pressed.
When this button is pressed after pressing
the TUNER button, the tuner’s power is
turned on; when it is pressed again, the
tuner is set to the standby mode.
When this button is pressed after pressing
the AMP button, the PM6002 is switched
from the power-on mode to the standby
mode or vice versa.
* The remote controller cannot be used to
turn the primary power of the amplifier ON
and OFF.
x Input selector buttons
• Input source Button
These buttons are for directly selecting the
input source. The AMP button is not used on
the PM6002.
Caution
In the PM6002, AUX and DVD, and
RECORDER 2’s TAPE and MD each share
the same input jacks. The signal codes for
controlling these Marantz products using the
RC002PM differ, therefore separate buttons
have been built into the remote controller.
• INPUT % Button
This button is for forward-feeding the input
source indications to select a desired
source.
The input source indication, which is
displayed on the function indicator on the
main frame, is fed to the right.
• INPUT fi Button
This button is for backward-feeding the
input source indications to select a desired
source.
The input source indication, which is
displayed on the function indicator on the
main frame, is fed to the left.
OPEN/
CLOSE
SOURCE
POWER
PHONO CD
RECODER 2RECODER1
AMP
TUNER AUX
MUTE
REPEAT
ENTER
TOP MENU
MODE
SCAN PROG.
CANCEL
RANDOM
MENU
INPUT VOLUME
DVD
CD-R TAPE MD
z
x
c
v
c VOLUME adjustment buttons
• MUTE Button
This button activates the mute function.
Pressing this button again releases the
MUTE function.
The MUTE function can also be released
by pressing either the VOLUME 5 or ∞
buttons.
• VOLUME 5 Button
This button increases the volume level.
• VOLUME ∞ Button
This button decreases the volume level.
v Component operating buttons
These buttons are for performing basic
operations of a Marantz CD player, DVD player,
etc. The function of each button changes to
match the component selected as the input
source using the input selector buttons.