Filter
Top Products
4
ENGLISH
NAMES AND FUNCTIONS OF PARTS
FRONT PANEL
qwe r ytu
io!0!1!2!3!4
q POWER SWITCH
Pressing once switches the power ON, and pressing again
switches it OFF.
If the POWER switch is in the ON position, the power of this
unit can be turned ON/OFF by pressing the POWER
button on the remote control unit.
w STANDBY INDICATOR
Lights up when the unit is in the standby mode.
e INPUT SELECTOR
Selects the program source to be recorded or played from
the PHONO, CD, TUNER, AUX/DVD, RECORDER 1
(CD-R), and RECORDER 2 (MD/TAPE).
r TONE DEFEAT SWITCH
• When the switch is not depressed, the audio signals are
applied to the tone control circuit and the tone can be
adjusted using the tone control knob.
• When the switch is depressed, the audio signals bypass
the tone control circuit and the balance control circuit.
Then, the tone control knob and the balance control
knob do not function.
t FUNCTION INDICATORS
One of the indicators lights up to indicate the input source
selected with the INPUT SELECTOR.
y MUTING INDICATOR
Light up when the MUTING button in the remote control
unit is pressed.
NOTE:
Be sure to check the VOLUME control setting before
pressing this switch to cancel muting. If the muting is
canceled while the volume setting is high, the speakers
could be damaged.
u VOLUME CONTROL
Adjusts the volume level. Turn the knob clockwise to
increase the volume.
i LOUDNESS SWITCH
The LOUDNESS switch compensates for human hearing
characteristics by boosting the bass and treble response at
low volume levels to achieve a more pleasing tonal balance.
o SPEAKERS 1 / 2 SWITCHES
These switches are used to select the speaker system(s)
connected to the SPEAKER SYSTEM 1 / 2 terminals on
the rear panel. If both the 1 and 2 switches are pressed to
the low positions, two speaker systems can be used at the
same time.
When headphones are used for listening, set both switches
1 and 2 to OFF (high positions).
!0 BALANCE CONTROL
Turn the knob to correct an unbalanced program source
such as stereo broadcast or to vary the output level of the
left or right channel. Note that, if the BALANCE control is
turned fully in one direction, the sound will not be heard
from the speaker on the other side.
!1 BASS AND TREBLE TONE CONTROLS
Adjusts the tone by controlling the levels of two frequency
bands. Turn each control toward (+) to enhance the
corresponding frequency band, or toward (–) to attenuate
it.
TREBLE: Adjusts the high frequency level.
BASS: Adjusts the low frequency level.
!2 REC SELECTOR SWITCH
Selects the tape dubbing mode between tape decks or the
signal output at the REC OUT jacks.
!3 REMOTE SENSOR
The remote sensor receives the infrared commands from
the remote control unit. When an infrared signal is received
from the remote control unit. The remote control unit must
always be pointed directry at the remote sensor.
!4 PHONES JACK
Insert the standard phone plug of the headphones into this
jack.
05.7.12, 1:10 PMPage 4