Filter
Top Products
6
ENGLISH
NAMES AND FUNCTIONS OF PARTS
í Loading batteries
Before using the supplied remote control unit for the first time,
load the batteries in the remote control unit. The batteries pro-
vided are used to verify the operations of the remote control
unit only.
(1) Remove the battery cover.
(2) Insert batteries with correct ª/· orientation.
(3) Close the battery cover until it clicks shut.
USING THE REMOTE CONTROL UNIT
í Remote control
Operate the remote control unit within a distance of approx. 5
m from the infrared signal reception window (remote sensor)
on the front of the Amplifier.
Remote control operation may not be possible if the remote
control unit’s transmitter is not pointing in the direction of the
remote sensor or if there is an obstruction between the
transmitteote sensor.
Remote control operating range
Remote control unit
Rear side
Two “AA” size
batteries
c. SOURCE POWER button
Switching the mode of a CD player, tuner, CD-R or other
Marantz component equipped with a power standby
function between power-on and standby is enabled by
pressing this button after the FUNCTION SELECT button
corresponding to the component has been pressed.
When this button is pressed after pressing the TUNER
button, the tuner’s power is turned on; when it is pressed
again, the tuner is set to the standby mode.
When this button is pressed after pressing the AMP
button, the PM4001 is switched from the power-on mode
to the standby mode or vice versa.
x FUNCTION SELECT button
PHONO button : When this button is pushed the input of
PHONO is selected.
CD button : When this button is pushed the input of
CD is selected.
TUNER button : When this button is pushed the input of
TUNER is selected.
RECORDER 1
(CD-R) button : When this button is pushed the input of
CD-R is selected.
AUX button : When this button is pushed the input of
AUX/DVD is selected.
DVD button : When this button is pushed the input of
AUX/DVD is selected.
RECORDER 2
(TAPE) button : When this button is pushed the input of
MD/TAPE is selected.
(MD) button : When this button is pushed the input of
MD/TAPE is selected.
CAUTION:
A pair of input jacks is used as the common input jacks for
the MD or TAPE input and another pair is used as the
common input jacks for the DVD or AUX input. The reason
an independent button is used for each input is that the
codes used by the RC4001PM to control the MARANTZ
MD recorder, tape deck and DVD recorder are different.
c VOLUME UP/DOWN button
UP button : VOLUME knob turns when this button
is pushed and the volume level is
grows.
DOWN button : VOLUME knob turns when this button
is pushed and the volume level is falls.
v MUTE button
When this button is pushed, the sound is not temporarily
emitted from the speakers.
When this button is pushed again, MUTE is released.
Moreover, when up/down of the volume is operated by
remote control, MUTE is released.
Other buttons are not applied to PM4001.
Please see at the owners manual of other equipment’s
about the operation of button.
Approx. 5 m
Amplifier
Remote control unit
60°
05.7.6, 0:06 PMPage 6