Filter
Top Products
18
English
8240 009 34231
Notes:
– During program play or shuffling mode, it is not
possible to repeat playback for the current disc
(Repeat Disc mode).
– Pressing the CD OPEN/CLOSE button will cancel
all repeat and shuffling modes.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1 Load the desired discs on the disc tray (refer to
“Loading discs”).
2 Press PROGRAM to start programming.
➜ PROG starts flashing.
3 Press CD 1/2/3 to select a disc.
4 Press í or ë repeatedly to select the desired
track.
5 Press PROGRAM to store the track.
● Repeat steps 3–5 to store other discs and
tracks.
6 To end programming, press Ç once .
➜ PROG stays and the program mode remains
active.
➜ The total number of tracks programmed and
the total playing time are displayed.
7 To start program play, pressÉÅ .
➜ "PLAY PROGRAM" is displayed.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" is displayed
instead of the total playing time.
– If you attempt to program more than 40 tracks,
"FULL" is displayed.
– During programming, if no button is pressed
within 20 seconds, the system will exit the Program
mode automatically.
To review the program
● Stop playback and press í or ë repeatedly.
● To exit review mode, press Ç.
Erasing the program
● Press Ç once when playback is stopped or
twice during playback.
➜ PROG disappears and "PROGRAM CLEARED"
is displayed.
Note:
– The program will be erased when the system is
disconnected from the power supply or when the
disc tray is opened.
For Recording, please refer to “Tape
Operation/Recording”.
CD Operation