Filter
Top Products
14
English
8240 009 34231
Demonstration mode
The system has a demonstration mode that
shows the various available features.
To activate the demonstration
● In standby mode, press and holdÇon the
system until "WELCOME" is displayed.
➜ The demonstration will begin.
To deactivate the demonstration
● Press and holdÇon the system until
"DEMO OFF" is displayed.
➜ The system will switch to standby mode.
Note:
– If you have not deactivated the demonstration, it
will resume five seconds after the system switches
to standby mode.
Switching the system on
In standby/demonstration mode
● Press STANDBY ON to switch on the last
selected source.
● Press CD 1/2/3, TUNER or
TAPE (TAPE 1/2).
● Press CD OPEN/CLOSE.
➜ The system will switch to CD mode.
Switching the system to standby
mode
In demonstration mode
● Press and hold Ç on the system.
In any other source mode
● Press STANDBY ON (or B on the remote
control).
➜ The clock will appear on the display when the
system is in standby mode.
Dim mode
You can select the desired brightness for the
display.
● In any source mode (except standby mode),
press DIM repeatedly to select : DIM 1, DIM 2,
DIM 3 or DIM OFF.
➜ DIM is shown, except for DIM OFF mode.
DIM
mode
1
2
3
OFF
Brightness
normal
half
half
normal
Spectrum
Analyzer
off
on
off
on
Note:
– In standby mode, pressing DIM to select half or
full brightness for clock display.
Volume control
Press MASTER VOLUME 3 or 4 (VOL +
or - on the remote control) to increase or
decrease the volume level.
To listen through the headphones
● Connect the headphones plug to
the n socket at the front of the
system.
➜ The speakers will be muted.
To switch off the volume temporarily
● Press MUTE on the remote control.
➜ Playback will continue without sound and
"MUTE" is displayed.
● To restore the volume, press MUTE again or
increase the volume level.
Basic Functions