Filter
Top Products
Listening to the Radio:
1. Turn the vehicle’s ignition key to
the “ON” or “ACC” position to pro-
vide power to the radio.
2. Rotate knob (1) clockwise to turn
the radio on. Adjust the volume
knob (1) to a low listening level.
3. Use the band button (4) to select
the AM or FM radio band. The FM
band has 3 banks (FM1, 2, and 3).
The AM band has 2 banks (AM 1
and 2)
4.
Use the tuning button (5) to select a
desired radio station. Press the
“ ” (up) button to tune to
higher radios stations. Use the “ ”
(down) button to tune to lower
radio stations. Pressing and releasing
the tuning control buttons (5) will
cause the tuner to move up or down
two decimal increments. Pressing
and holding the up or down tuning
buttons (5) will cause the tuner to
count up or down at high speed.
5. If you are traveling in an area
where you are not familiar with the
local radio stations, press and
release the scan button (6). This
will activate the auto tuning system
and the tuner will scan up to the
next available strong station and
stop for 5 seconds. After 5 seconds
has passed, the tuner will search up
to the next strongest station and
stop. If you find a station to your
liking, simply press and release the
scan button once again to stop the
scan operation.
6. Adjust the tone, fader, balance and
volume controls as needed using
the information “Audio adjust-
ments” section of this manual.
Display Priority Note:
The priority of the display area (9) is
for the clock. 5 seconds after the last
tuning control command, the display
will change and display the clock. To
recall the radio frequency, press and
release the “R.Freq” button (7). The
display will change to show the radio
frequency then will revert back to the
clock after 5 seconds.
Listening to the Weatherband Radio
1. At any time when the AM/FM
radio is playing, you can press the
“Weather” button (8). The auto-
matic weatherband seek tuning
will begin to find the strongest
broadcast frequency in the area
you are traveling in. When the
weatherband radio is activated
“WB” will appear in the display
area (9c) figure 4. Once the tuner
has locked on to a station, the
weatherband radio will operate.
2. To turn the weatherband radio off,
press the “weather” button (8)
once more and the unit will return
to the signal source (AM/FM) you
were previously listening to.
3. 7 weather stations are available. If
you would like to scroll though the
stations, press the weather button
(8) to activate the weatherband
and then press the “ “ or “ “
tuning button (5) to scroll up or
down the 7 stations.
Note: All 7 stations may not be
available in the area you are traveling
in.
8
<
<
<
<
Using the Radio