Filter
Top Products
5
Radio Operation
Select a Band
In Tuner Mode, press the "BAND" button (16) to
select the desired band in the following order:
FM1, FM2, FM3, AM1, AM2. Each band can store
up to six preset stations.
Band Button
Press the "BAND" button (16) while in Radio
Mode to change to CD Mode.
Tuning
Manual Tuning: Press and hold the or
button (3) for more than 4 seconds then release.
Then press and release the or button until
desired frequency is selected. The unit will default
back to Seek Tuning Mode after 5 seconds of no
button activity.
Seek Tuning: Press the or button to move
to the next station automatically.
Automatically Store Stations
Select six strong stations and store them in the
current band:
Select a Band (if needed). Press and hold the
button (11) for more than three seconds.
The new stations replace stations already stored
in that band.
Sound Controls
Preset Scan
Scan stations stored in the current band:
Select a Band (if needed). Press the button
momentarily. The radio pauses for ten seconds at
each preset station. When desired station is
reached, press the button again to stop
scanning.
Preset Stations
Six numbered preset buttons store and recall sta-
tions for each band.
Select a Band (if needed). Select a station by
pressing the or button. Press and hold
any of the preset buttons for three seconds to
memorize the station. The preset number will
appear in the display.
Recall a Station
Select a Band (if needed). Press one of the six
preset buttons to select a stored station.
Scan
Press the button (13) to scan through strong
stations in the current band. The radio will pause
for five seconds at each strong station. To listen
to the current station, press the button again.
Audio Mode Selection Button
Selects the desired audio mode by pressing the
button (24). The modes will be displayed the
following order: Volume, Bass, Treble, Balance
and Fader.
Volume
Adjust the volume by pressing the or button.
O = Minimum Volume
46 = Maximum Volume
Initial Volume Level
To program the Initial Volume Level, adjust the
volume to the desired level, then press and hold
the PWR button for more than 3 seconds. The
next time the unit is turned on, the volume will be
at this initial level.
Bass
Press SEL button two times. Adjust the Bass up
or down by pressing the or button.
-6 = Minimum Bass
+6 = Maximum Bass
Treble
Press SEL button three times. Adjust the Treble
up or down by pressing the or button.
-6 = Minimum Treble
+6 = Maximum Treble
Balance
Press SEL button four times. Adjust the Balance
left or right by pressing the or button.
R12 = Right speakers only
C0 = Equal sound right and left
L12 = Left speakers only
Fader
Press SEL button five times. Adjust the Fader
front or rear by pressing the or button.
R12 = Front speakers only
C0 = Equal sound front and rear
L12 = Rear speakers only
M3100CDUM .qxd 07/24/03 4:17 PM Page 5