Filter
Top Products
SP1200 – 24
SP1200 MUSIC CONTROLLER
SP1200 Specifications
Power Amplifier Section
Continuous Sine Wave Average Output Power, single channel
driven:
200 watts into 8 ohms from 20Hz to 20kHz, with no more than 0.01%
THD
100V RMS into 50 ohms from 20Hz to 20kHz, with no more than
0.1% THD (J2/J3 in 100V position)
70V RMS into 25 ohms from 20Hz to 20kHz, with no more than 0.1%
THD (J2/J3 in 70V position)
Frequency Response
20Hz to 20kHz (+0, –0.5 dB)
Distortion
THD: < 0.01% @ rated output into 8 ohms
Signal-To-Noise Ratio
> 90 dB below rated power into 8 ohms
> 100 dB (A-weighted) below rated power into 8 ohms
Channel Separation
> 80 dB @ 1kHz
Amp Input Impedance
20k ohms
Input Sensitivity
+5 dBu (1.37V rms) for rated power into 8 ohms
Gain
27 dB (8-ohm position)
27 dB (70V position)
30 dB (100V position)
Maximum Input Level
12 volts P-P (+15 dBu)
Rise Time
< 5 µS
Slew Rate
> 17V/µS
Preamplifier Section
Input Levels
Program Inputs: –10 dBu to +10 dBu for
maximum output level
with internal AGC
Paging Mic Input: –52 dBu to +4 dBu
Local Mic Input: –52 dBu to +4 dBu
Maximum Input
Program Inputs: +15 dBu
Mic Inputs: +15 dBu
Maximum Output at Pre Out
+10 dBu
EQ
3-Band Program EQ:
High Shelving: ±15 dB @ 12kHz
Mid Peaking: ±15 dB with sweepable frequency
(250Hz to 8kHz)
Low Shelving: ±15 dB @ 80Hz
2-Band Mic EQ:
High Shelving: ±12 dB @ 12kHz
Low Shelving: ±12 dB @ 100Hz
General
Power Consumption
700 watts with musical program, 8 ohms per side
800 watts maximum
Phantom Power
24V DC
AC Line Voltage
115V AC, 60Hz
230V AC, 50Hz (internally switchable)
Fuse Rating
115V 4A Slow Blow, 250V
230V 2A Slow Blow, 250V
Dimensions
Height: 3.5" (88 mm)
Width: 19.0" (483 mm)
Depth: 16.7" (424 mm)
Weight: 25 lbs. (11.2 kg)
Accessories
MT-3100 Ambient Noise Sensing Microphone
SP-41R Remote Control