Mackie 1800SA Speaker User Manual


  Open as PDF
of 12
 
6
CONNECTIONS
Balanced XLR Connectors
POWER OUT
35-85Hz
MIN. 8
14
23
+–
The
LOOP OUT
connector allows you to
connect more than one FUSSION 1800SA
to the
SUB OUT
connector from your
FUSSION full-range active speaker system.
Simply plug the
SUB OUT
into the first
MAIN INPUT
jack, and patch that speaker’s
LOOP OUT
jack to the next
MAIN INPUT
jack, and so on, daisy-chaining multiple
speakers.
The
LOOP OUT
jack is wired straight
from the
MAIN IN
connector — there is no
electronic circuitry between — so the signal
coming out of the
LOOP OUT
jack is exactly
the same as the signal going in.
The
POWER OUT
connector delivers a
speaker-level signal to the FUSSION 1800S
cabinet. Use 4-pin Neutrik™ Speakon con-
nectors on heavy-gauge speaker wire. The
connector is wired as follows:
Neutrik
Hot (+) Pins 3 and 4
Cold (–) Pins 1 and 2
The FUSSION 1800SA has a female
XLR input that accepts a balanced line-level
signal. When connecting a balanced signal,
be sure it’s wired per AES (Audio Engi-
neering Society) standards:
XLR
Hot (+) Pin 2
Cold (–) Pin 3
Shield (Ground) Pin 1
There is also a male XLR connector la-
beled
LOOP OUT
. This is also wired
according to the above AES standard.
FUSE
NEMA LS-20 20A-115VAC
FUSE
16A / SB
OFF
ON
POWER
CONCEIVED, DESIGNED, AND MANUFACTURED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA
AND MACKIE EUROPE • MANUFACTURED IN ITALY • COPYRIGHT ©1998 •
THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.:
"MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING
LOOP OUT
POWER OUT
35-85Hz
MAIN INPUT
PARALLEL
MIN. 8
WARNING:
THIS SURFACE MAY REACH HIGH TEMPERATURE DURING
STANDARD USE. TO ENSURE PROPER OPERATION ALLOW A MINIMUM OF 6 INS.
OF CLEARANCE FROM THIS SURFACE AND ADEQUATE VENTILATION. TO REDUCE
THE RISK OF ELECTRIC SHOCK DO NOT REMOVE THIS PANEL OR ANY ATTACHED
COMPONENT. NO OPERATOR SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
UTILISE UN FUSIBLE DE RECHANGE DE MÊME TYPE.
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE
CAUTION
AVIS :
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
SERIAL NUMBER
MANUFACTURING DATE
1800SA
FUSSION
FS
™
FUSE
3000
FUSSION
WARN ING :
THIS SURFACE MAY REACH HIGH TEMPERATURE DURING
STANDARD USE. TO ENSURE PROPER OPERATION ALLOW A MINIMUM OF 6 INS.
OF CLEARANCE FROM THIS SURFACE AND ADEQUATE VENTILATION. TO REDUCE
THE RISK OF ELECTRIC SHOCK DO NOT REMOVE THIS PANEL OR ANY ATTACHED
COMPONENT. NO OPERATOR SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
UTILISE UN FUSIBLE DE RECHANGE DE MÊME TYPE.
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE
CAUTION
AVIS :
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
SERIAL NUMBER
MANUFACTURING DATE
FS
CONCEIVED, DESIGNED, AND MANUFACTURED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA
AND MACKIE EUROPE • MANUFACTURED IN ITALY • COPYRIGHT ©1998 •
THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.:
"MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING
™
10
0
MAIN INPUTLOOP OUT
PIN 1- GND / PIN 2- POS (+) /
PIN 3- NEG (-)
HIGH PASS
85Hz - 20kHz
FULL RANGE
55Hz - 20kHz
POWER (GREEN)
PROTECT (RED)
FILL OUT
85Hz - 20kHz
OUTPUT
LEVEL
SUB-OUT
20Hz - 85Hz
PHASE
0˚ 180˚
MAIN INPUT
ON
FUSE
16A / SB
NEMA LS-20 20A-115VAC
PARALLEL
FUSE
NEMA LS-20 20A-115VAC
FUSE
16A / SB
OFF
ON
POWER
CONCEIVED, DESIGNED, AND MANUFACTURED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA
AND MACKIE EUROPE • MANUFACTURED IN ITALY • COPYRIGHT ©1998 •
THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.:
"MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING
LOOP OUT
POWER OUT
35-85Hz
MAIN INPUT
PARALLEL
MIN. 8
WARNING:
THIS SURFACE MAY REACH HIGH TEMPERATURE DURING
STANDARD USE. TO ENSURE PROPER OPERATION ALLOW A MINIMUM OF 6 INS.
OF CLEARANCE FROM THIS SURFACE AND ADEQUATE VENTILATION. TO REDUCE
THE RISK OF ELECTRIC SHOCK DO NOT REMOVE THIS PANEL OR ANY ATTACHED
COMPONENT. NO OPERATOR SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
UTILISE UN FUSIBLE DE RECHANGE DE MÊME TYPE.
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE
CAUTION
AVIS :
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
SERIAL NUMBER
MANUFACTURING DATE
1800SA
FUSSION
FS
™
FUSE
3000
FUSSION
WARN ING :
THIS SURFACE MAY REACH HIGH TEMPERATURE DURING
STANDARD USE. TO ENSURE PROPER OPERATION ALLOW A MINIMUM OF 6 INS.
OF CLEARANCE FROM THIS SURFACE AND ADEQUATE VENTILATION. TO REDUCE
THE RISK OF ELECTRIC SHOCK DO NOT REMOVE THIS PANEL OR ANY ATTACHED
COMPONENT. NO OPERATOR SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
UTILISE UN FUSIBLE DE RECHANGE DE MÊME TYPE.
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE
CAUTION
AVIS :
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
SERIAL NUMBER
MANUFACTURING DATE
FS
CONCEIVED, DESIGNED, AND MANUFACTURED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA
AND MACKIE EUROPE • MANUFACTURED IN ITALY • COPYRIGHT ©1998 •
THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.:
"MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING
™
10
0
MAIN INPUTLOOP OUT
PIN 1- GND / PIN 2- POS (+) /
PIN 3- NEG (-)
HIGH PASS
85Hz - 20kHz
FULL RANGE
55Hz - 20kHz
POWER (GREEN)
PROTECT (RED)
FILL OUT
85Hz - 20kHz
OUTPUT
LEVEL
SUB-OUT
20Hz - 85Hz
PHASE
0˚ 180˚
MAIN INPUT
ON
FUSE
16A / SB
NEMA LS-20 20A-115VAC
PARALLEL
MIXER
FUSSION 1800S FUSSION 1800S
FUSSION 1800SA
FUSSION 3000
FUSSION 1800SA
FUSSION 3000
 previous next