Filter
Top Products
2
2
A B C ADJ-OFF
1234
5678
GLOBAL
Z-ADJ
TREBLE
VOL
MUTE
ON OFF
E-FLAT LAST MAX-V TRIM
OFF C-BAL
BASS
INPUT
A
RC68+ PROGRAMMER
80 48 10 90 01
00 C0 50 D0 41
40 A0 30 B0 21
20 E0 70 F0 61
60 88 18 98 09
08 A8 38 B8 29
28 E8 78 F8 69
68 C8 58 D8 49
E1 89 C9 A9 E9
71 19 59 39 79
F1 99 D9 B9 F9
3
4
5
1
RC68 PROGRAMMER / REMOTE CONTROL
The RC68+ (and the RC68) programmer (available separately) contains all the commands necessary to
operate the RAT1.
• You will need it to program universal learning devices such as the Xantech URC-1 learning remote, the
Xantech Smart Pads, the 590 Programmable Controller, the 710 Fone Link, etc., with commands that
operate the RAT1.
• NOTE: The RC68+ codes operate several other Xantech models as well, such as the RS41AV, CC12,
ZPR68, MIRV1, etc. Therefore,
only
the button descriptions that apply to the operation of the RAT1 are
listed below. All others should be ignored.
CAUTION: While the RC68+ can be used as a handheld remote control, it is highly recommended it not
be given to the final user for the following reasons:
• Since it includes selectable code groups, the user may inadvertently alter the installer configurations.
• Since the user will require IR commands from other brands of equipment to control the total system, in
addition to those of the RAT1, all commands should be consolidated into one learning device for easy use.
APPLICABLE RC68+ BUTTON DESCRIPTIONS
1. IR Emitter Lens
2. Instant Volume Presets. These buttons allow direct preset activation of any of the 10 volume steps
on the RAT1. Useful for "audio scene" ambiance settings for rooms or an instant partial mute action.
The relationship of the RC68 buttons to the RAT1 volume step positions is as follows:
RC68+ Button RAT1 Volume Step #
A, B, C 1 (OFF, MIN. VOL)
ADJ-OFF 2
13
24
35
46
57
68
79
8 10 (MAX VOL)
3. VOLUME Up/Down buttons. Each individual press will cause the RAT1 to
increase or decrease volume level by one step, over a total of 10 steps. Each step causes a change
of 3 to 6 dB. A maximum attenuation of 35 dB occurs at the lowest active step (#2). The lowest step
(#1) switches the signal off. When buttons are held down, volume level changes continuously.
4. MUTE ON/OFF. Separate ON / OFF buttons mute and release the signal without knowing what the
status is. This is very helpful in a remote room when all adjustments are made “blind” without any visual
aid for status.
NOTE: Mute is released (turned off) when a VOLUME or Preset Level button is pressed, in addition
to MUTE OFF.
5. Code Group Numbers. If more than one RAT1 is used on a common IR controlled bus, or is included
with other Xantech products that respond to RC68+ commands, different Code Groups can be
assigned, by the installer, to avoid mutual interaction. Refer to the RC68+ instructions for Code Group
setting procedures.
NOTE:
When shipped from the factory, the RAT1 is set to Code Group number 30. Be sure to
set the RC68+ to the same number!
RAT1
Fig. 2 The RC68+
Programmer