Filter
Top Products
Troubleshooting26
Troubleshooting
4
Troubleshooting
General
Problem Cause & Solution
No Power.
The power cord is not plugged in. Plug in the power cord.
Check whether electricity failed. Check the condition by operating other
electronic devices.
No sound.
Check whether you select right function. Press FUNCTION and check the
selected function.
If not, connect speaker cables correctly. Speaker cables connected
correctly.
The unit does not start
playback.
An unplayable disc is inserted. Check the playable disc.
No disc is inserted. Insert a disc.
The disc is dirty. Clean the disc.
(Refer to the 30 page)
The disc is inserted upside down. Place the disc with the label or printed
side facing upwards.
Radio stations cannot
be tuned in properly.
The antenna is positioned or connected poorly. Connect the antenna
securely.
The signal strength of the radio station is too weak. Tune to the station
manually.
No stations have been preset or preset stations have been cleared (when
tuning by scanning preset channels). Preset some radio stations, see page
20 for details.
The remote control
does not work properly.
The remote control is too far from the unit. Operate the remote control
within about 23 ft (7 m).
There is an obstacle in the path of the remote control and the unit. Remove
the obstacle.
The batteries in the remote control are exhausted.
Replace the batteries
with new ones.
iPod does not work.
Check whether the player is connected to the unit correctly. Connect it to
the unit correctly.
Sub woofer does not
work.
Check whether the woofer is connected to the unit correctly. Connect
cables to the unit correctly. (Refer to the 13 page)
Press WOOFER POWER and check the woofer status.