Filter
Top Products
Microboards CopyWriter Live
13
In the Setup menu, press the No button until System Update is selected. Press the Yes/Setup button
and the left drive will eject, prompting you to place the firmware disc in the drive with the message
Insert Program Disc. Place the disc in the drive and close the tray
The new firmware will be read by the system and then copied into the CopyWriter Live.
After the firmware is updated, you will need to shut the CopyWriter Live off and restart it. Once the
system boots back up, it is ready to use with the new firmware installed. Input, Volume, and Gap
Sizes will be returned to the default values.
Auto Track Index
This feature allows you to have the Copywriter Live automatically create tracks based on the time
period you select.
Press Yes/Setup button when the Setup menu display reads AUTO Trk INDEX. The first selection
is No, which will not create tracks automatically. The choices which will allow auto tracking are 3
minutes, 5 minutes, 7 minutes, and 10 minutes. Press No until the correct interval appears, then
press Yes/Setup to select that interval.
You can still manually index tracks even with the Auto Track Index feature turned on by pressing
the Record button. The next auto track will be the length you have specified in the Auto Track
Index.
Note that the gap between tracks will be set based on the Gap Size setting (see below).
Gap Size
The length of silence in between audio tracks can be set by changing the Gap Size value. The Gap
Size value ranges from 001 to 150. At 150, the gap is 2 seconds. At 001 the gap is approximately
1/75 of a second. The default value is 001.
Use the Vol Up and Vol Down buttons to change the Gap size.
Recording
The Copywriter Live can run in Span mode or in Twin mode. The default setting is Span mode.
For uninterrupted recording, you should select Span mode. As the first disc fills, the second
automatically starts burning. Another blank disc can be loaded in the first drive, so when the second
disc fills, the new blank disc begins burning. This sequence can be continued indefinitely.
To burn 2 identical discs from the same audio input, select Twin mode. The CopyWriter Live will
burn to both drives at the same time; when the discs are full, the recording stops and the discs are
automatically closed and ejected. If you wish to continue recording, replace both discs with blank
media and press the Record button once the discs are ready.
Setup Exit?
Press Yes/Setup to leave the Setup menu, or No to cycle through the options again.