Filter
Top Products
Microboards CopyWriter Live
10
Copying a Disc
To copy a disc, all you need to do is place a blank disc in one drive and the master disc in the other
drive. It does not matter which drive contains the master and which drive contains the blank. Press
the Disc Copy button on the CopyWriter Live front panel and the copy process will begin. Please
follow these steps to copy a disc.
1. Place your master disc you wish copied into either of the two recorders. The display for that
drive will change to read the type of disc it is, such as Data CD or Audio CD.
2. Place your blank CD-R or CD-RW disc into the other recorder. The display will change to
Blank Disc. It will also display the total time available on that disc.
3. Press the Disc Copy button on the front panel.
4. The copy process will now start. The display will show you the progress of the copy job.
NOTE: If your master disc is larger than your blank disc, you will see the message SPACE
NOT ENOUGH. If you see this message, you will need to use a higher capacity blank disc.
CopyWriter Live Menu Options
Pressing the Yes/Setup button while no recording or playback is taking place will take you into the
Setup menu. Pressing the Yes/Setup button at each displayed item will allow you to make changes
to the specified setting.
Input
This menu option allows you to switch the default input selection. Note that you can change the
input selection at any time except during recording by pressing the Input button, but this will not
change the selection that first appears when the CopyWriter Live is turned on. The CopyWriter Live
default for input selection is Input 1.
Choices for the input selection are INPUT 1, INPUT 2, XLR, and MIC.
Volume
You can control the input volume for each input selection of the CopyWriter Live system. A
different volume level can be saved for each input selection.
Press the Yes/Setup button to change the volume for the displayed input selection, or No to move to
the next selection. After pressing Yes/Setup, use the Vol Up and Vol Down buttons to change the
volume setting for the input selection. Press Yes/Setup again to save the new volume level and
return to Volume in the Setup menu. Pressing No will discard the changes.
The input volume can also be controlled during recording by using the Vol Up and Vol Down
buttons.
CD Tools
The CD Tools menu item allows you to close an open Audio CD. It also allows you to erase a CD-
RW disc. Press Yes/Setup when you have selected the CD Tools entry on the Setup Menu. There
are 3 options under the CD Tools menu:
Close Disc