Filter
Top Products
IB-CD1493(AD-63D)-WM-E-1203036
ATTACHING THE SPEAKERS
6.Carefully unwind the speaker wire from behind each speaker box and plug the
right plug into SPEAKER JACK R, also plug the left plug into SPEAKER
JACK L (as shown in FIG. 3). Wrap the remaining wire behind each speaker box.
NOTE: The right and left speakers are NOT
interchangeable. The right speaker
fits only on the right side (as shown
in FIG. 1). The left speaker fits only
on the left side.
1.Bring the right speaker to the right side
of the set.
2.Raise the right speaker box about 4
inches above the set. Align the
tracks (rails).
3.Fit speaker over the side rails.
4.When speaker fits over the rails, lower
the speaker as shown in FIG. 2, and make
sure the tabs snap into the speaker
box (locks in the back).
5.Repeat above steps 1 to 4 for the left
speaker box.
NOTE: This set can be used with speaker boxes attached to the main set or
separated, just make sure both speaker plugs are plugged into the jacks.
To remove the speakers, press the lock tab and raise the speakers.
FIG.1
FIG.2
FIG.3
LOCK TAB