Filter
Top Products
IB-CD1493(AD-63D)-WM-E-120303
CHOOSING THE POWER SOURCES
You can use the AC power or batteries as a power source.
1. Connecting the AC power
cord
Insert one end of the supplied AC power cord
(located in the battery compartment) into the socket
located at the rear of the player, and the other end
to the wall outlet.
2. Using the player on batteries
Insert 8 size “D” batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect the AC
power cord both from the outlet and the back of
the player.
5
NOTE: One blade of plug
and outlet is wider.
TIP
•
If the plug of the AC
power cord does not
match your outlet, do not
force it.
Reverse it and try again.
The plug is polarized
and only fits one way into
the wall outlet and back
of the set.
•
Replace the batteries
when the POWER lamp
dims or when the player
stops operating. Replace
all the batteries with new
ones. Before you replace
the batteries, be sure to
take out the CD from the
player and remember to
check the Battery Safety
Instructions on Page 3.
If the CD does not play
on batteries, this means
the batteries are almost
used up. But the radio
may continue to play on
these weak batteries
because it uses less
power than the CD
player.
•
To a wall outlet
Battery compartment
AC SOCKET