Legend Audio ATP 7500 Stereo Amplifier User Manual


 
Page 4
General Recommendations
Before you begin the SETUP, we strongly recommend that you
take a few moments to:
Familiarize yourself with the controls and functions of the
preamplifier-processor.
Carefully study the system connection diagrams and basic
operational instructions.
Fully understand the setup and programming instructions.
Precautions
Install the ATP7500 on a solid shelf.
Be sure that the area surrounding the unit is well
ventilated and not near a heat source of any kind.
Prevent any moisture from entering the unit.
Do not place anything on top of the unit.
Make all connections BEFORE you turn the unit on.
Front Panel Controls
A Power Switch
Switches the unit into standby mode and the LED turns on.
Do not use this switch to turn the unit off; use the OFF button.
PLEASE NOTE: TO TURN THE UNIT ON, YOU MUST
SELECT A SOURCE EITHER ON THE FRONT PANEL
OR THE REMOTE CONTROL.
B Source Buttons
When a source button is pressed, that source is selected
and the unit is turned on from the STANDBY mode.
C Seek Up
Advances the tuner to the next higher valid station.
D Volume Up
Raises the volume in 1dB increments. The volume will
increase faster if the button is held down.
E7.1
Selects multi-channel audio and DVD Video.
F AM/FM
Selects AM or FM reception.
G Seek Down
Advances the tuner to the next lower valid station.
H Volume Down
Lowers the volume in 1dB increments. The volume will
decrease faster if the button is held down.
I Zone 2
Toggles the CD, TAPE, TUNER, AUX source buttons, AM/FM,
VOLUME, MUTE, SEEK, and OFF to control ZONE2. If no
settings are selected,the display will default to MAIN ZONE.
J Mute
Toggles the muting for MAIN ZONE and ZONE2.
KOff
Turns the system from ON to Standby.
KJIHGFE
B CA D