Filter
Top Products
Remote Control Operation
The remote control is preprogrammed to operate the ATP7500
Digital Preamplifier-Processor in the AVC mode. It also has 7
other Device modes (accessed via the top two rows of buttons)
including CD (CD player), DVD (DVD Player), AUX (auxillary),
SAT (satellite), TV (television), VCR (videocassette recorder)
and CBL (cable box) for learning functions from the remote
controls of other equipment from other manufacturers. A red
backlight appears under the Device buttons when functions
for that device are selected on the remote. The red light
under the Device button is also used during programming
and setting up the remote control. For instructions on
learning new commands, turn to page 14.
PLEASE NOTE: The top left pushbutton on the remote
control labeled “AVC” must be selected before using
the remote control to operate the ATP7500.
POWER
This key operates the same way as the STANDBY button on
the front panel. It sends the command to switch the ATP7500
into or out of standby mode. This button cannot turn the unit
on; you must use one of the input selection buttons located
further down on the (i.e. DVD, LD, VCR1, VCR2, etc.)
VOL ▲ and VOL ▼ (UP and DOWN)
When you press the ▲ key, you will increase volume setting,
and when you press the ▼ key, you will decrease volume
setting. These keys work exactly the same way as the rotating
volume control on the front panel. If the ATP7500 is in the
mute mode (after you have pressed the MUTE key on the
handset), and you then press the VOLUME ▲ key, the ATP7500
will automatically disengage the mute mode and re-connect
the signal to the power amplifier and the loudspeakers. This
prevents mistaken setting an excessively high volume level.
CH ▲ and CH ▼ (UP and DOWN)
When you press the ▲ key, you will seek up, and when you
press the ▼ key, you seek down the AM/FM tuner frequency.
MUTE
When you press the MUTE key, it will engage mute mode and
the ATP7500’s line outputs will be muted. MUTE is a toggle
function, so when you press the key again it will disengage the
mute mode. Mute mode is also disengaged when you increase
the volume setting by using the VOL ▲ key on the remote.
TV
Toggle between NTSC and PAL video system (for OSD only).
GUIDE
When you press this key once, the status of the ATP7500 will
be displayed on the OSD. The status display shows selected
source, audio and video signal type, audio output type and
volume information. The status display disappears after ten
seconds or when you press the same key again.
Page 12