Filter
Top Products
Page 15
To Erase a Learned Command
From a Button
Step 1. Press the Device button and SELECT buttons
simultaneously, and hold until the orange Status LED
and the Device button turn on and remain lit.
Step 2. On the remote control, press the button that is to be
erased. The orange Status LED will flash continuously
and the Device button will turn off.
Step 3. Press the LIGHT button. The green status LED will
flash twice, then turn to a steady orange. The
Device button will turn on.
Repeat from Step 2 for any other buttons to be erased in the
selected Device mode.
Step 4.
To exit this feature, press and hold the Device button
and the SELECT button simultaneously, once again.
The orange Status LED will flash twice and then
turn off. The Device button will turn off.
To Erase All the Learned Commands
In One Device Mode
Step 1. Press the Device button and SELECT buttons
simultaneously, and hold until orange Status LED
and the Device button turn on and remain lit.
Step 2. Press and hold the LIGHT button. The red Status LED
will flash five times. Release the LIGHT button. The
Status LED will then flash green twice and then the
Device button will turn off. The Status LED will go to
a constant orange indicating
that all the learned
information on buttons in the Device mode have
been erased. The Device button will turn on.
Step 3. To exit this feature, press and hold the Device
button and the SELECT button simultaneously.
The orange Status LED will flash twice and then
turn off. The Device button will turn off.
To Erase All the Learned Commands
In All Device Modes
Warning: This procedure will erase all
learned commands on all buttons in the
CD, DVD, AUX, SAT, TV,VCR and CBL device modes.
Step 1. Press and hold the TV Device button and the LIGHT
button simultaneously. The red Status LED will flash
continuously. The Status LED will then flash green
once, orange once then turn off, indicating that all
of the learned commands on all of the Device
modes on the remote control have been erased.
Volume Punch Through
The user can have the Audio Volume controls (VOL ▲, VOL ▼
and MUTE) operate in any of the eight Device modes.
Step 1.
Press the Device and MUTE buttons, simultaneously.
Step 2. Press the
VOL ▲
button.
Step 3. Press the AVC device button to select the type of
volume control you wish to operate in that mode.
Example: If you wish to have the AVC volume operate in the
DVD mode, press the DVD Device button in Step 1. of the
instructions and the AVC Device button in Step 3.