Filter
Top Products
AO-BTHD USER MANUAL
6
PAIRING THE AO-BTHD WITH OTHER BLUETOOTH DEVICES
Entering the pairing mode:
Function Operation LED indicator Indication tone
Enter pairing
mode
Make sure the headset is off.
Press and hold MFB button for 6
seconds, until the red and blue
LED blink alternately
Red and blue LED
blinks alternately.
2 x audible tones
A: PAIRING AO-BTHD WITH MOBILE PHONE (HFP)
Ensure your mobile phone has Bluetooth capability
Pairing procedures may vary between brand types and handsets. Please refer to your mobile
phone manual for further information
• Please keep the headset and mobile phone within 1 meter of each other whilst
pairing.
• Activate the headset pairing mode (hold the MFB (middle button) for 6 seconds - the
red and blue LED will blink alternately)
• Activate the Bluetooth function on your mobile phone so it can search (discover)
Bluetooth devices.
• When located, Select AO-BTHD in the Bluetooth device list on your phone.
• If a password or PIN is required, enter 0000, and press Yes or Confirm if required.
• After successfully pairing, select AO-BTHD in the Bluetooth device list and press
connect on your mobile phone.
• If the pairing is successful a blue LED on the headset will blink.
Note:
• If the pairing is not successful, switch off the headset, and then restart the
procedure. Your device may also need to be reset.
• After pairing is successful, the paired devices will be stored in memory so there is no
need to repeat the pairing process. Some devices may only allow you to pair one set
of Bluetooth headsets at a time however you can use the AO-BTHD on multiple
devices (but not at the same time)