Filter
Top Products
34
35
ON
OFF
POWER
FUSE: T2A / 250V
AC FUSE
120V 60Hz160W
ATTENTION
CAUTION
RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DESIGNED IN USA MADEIN CHINA
SERIAL NUMBER
MODEL wAv 210
CAUTION
CHASSIS SURFACE HOT
SUPERFICE DE CHASSIS CHAUDE
ATTENTION
FOOTSWITCH LEFT
Line Out
RIGHT
Line Out
PREAMP
Out
POWER
AMP IN
PREAMP
Out
POWER
AMP IN
LEFT RIGHT
33
29
30
31
32
TAB
Power ON/OFF Switch:
AC Power Cord Receptacle:
Footswitch Jack
Left and Right Line Out:
Left and Right Preamp out:
Left and Right Power Amp In
:
:
Turns AC power on and off.
Insert the AC cord (provided) firmly into the AC
connector. NOTE: Replace the AC power cord if
protective jacket is damaged or ground pin is
damaged or removed.
The fuse is located in a housing just below the
receptacle. Replace only with same type and size.
To remove the fuse, remove AC power cord and
pull out on the tab above the fuse symbol
located on the fuse carriage. Place the new fuse in
the carriage clip and re-insert. NOTE: To prevent
an electrical hazard, DO NOT replace fuse
without using the fuse carriage. Replace the fuse
carriage if lost or damaged before re-inserting the
AC power cord.
Plug Footswitch into this connector using the
supplied cable. If the cable is lost or damaged, a
standard CAT 5 cable can be used. CAT 5 cables
can be purchased at your local retail electronic and
computer stores.
These ¼” mono jacks deliver the signal going to the
speakers at an unbalanced line level. The main
purpose of these jacks is to deliver line level
outputs to external sound reinforcement devices
such as powered monitors or speakers. They will
not drive external non-powered speakers. To
prevent an undesirable feedback oscillation, do not
use these jacks on signal processors or effects that
will be using the power amp input jacks.
These ¼” mono jacks deliver an unbalanced line
level output from the preamp and digital effects.
The main purpose of these jacks is to send a signal
to the input of third party signal processors or
effects that will be using the power amp input
jacks. These jacks do not interrupt signal flow from
the preamp to the power amp.
These ¼” mono jacks allow the left and right power
amplifiers to be used with an external line level
input. The main purpose of these jacks is to receive
the return signal from a third party signal processor
or effect. NOTE: When used, these jack will
interrupt the signal flow from the preamp to the
power amp.
FUSE:
8
Rear Panel