Filter
Top Products
Model wAv 210 Stereo guitar amp with digital effects and selectable preamps
Input Impedance
Output Power 30W per channel 8 Ohms @ 5% THD
Hum & Noise -50dB Residual Noise, all level controls 0% (minimum)
30 dB Lead Channel, Clean Preamp output
40dB Lead Channel, Classic Preamp output
60dB Lead Channel, Crunch Preamp output
60dB Lead Channel, Wave Preamp output
6dB Lead Channel added gain for all settings with Boost on
35dB Rhythm Channel, Shift Out
40dB Rhythm Channel, Shift In
35dB Power amp gain
USA/Canada 120VAC/60Hz, 100W nominal
Europe 230VAC/50Hz, 100W nominal
UK 230VAC/50Hz, 100W nominal
Australia 240VAC/50Hz, 100W nominal
Japan 100VAC/50-60Hz, 100W nominal
mm/kg 485 (Height) x 560 (Width) x 280 (Depth), 19.1kg
Inches/Pounds 19 (Height) x 22 (Width) x 11 (Depth), 42 lbs
200K Ohm
18 Bit 44.1Khz sampling rate Stereo Processor with onboard firmware flash memory
64K User Memory
Use any standard CAT 5 cable wired to the 568A or 568B standard
Use only with Model: KAC-FSWAV (supplied with amplifier)
Total Harmonic Distortion
Frequency Response 20HZ-20kHz
Actual response is tailored to speakers for accurate acoustical
response using a guitar as input.
Less than 0.4%
Because of the intentional distortion created by using some of the
preamps and effects, this Distortion is measured from the power
amp input signal to the output to speakers.
Dimensions
Power Requirements
Digital Effects
Footswitch
System Gain
All measurements taken with 1 KHz
inputsignal, Tone controls flat, Gain
and Volume MaximumBoostoff
unless noted. Measured atpreamp
outputjacks on rear unless noted.
There are 45 selectable effects separated into 3 groups of 15. One effect from each group
active at the same time. Up to 3 groups active at the same time.
There are 12 user presets. Each preset stores all setting for the 3 groups. There are 4
Favorites banks. Each favorites bank contains 3 user presets. Presets in the banks are
selected by tracking the channel select and Lead Boost button status.
13
Specifications