Filter
Top Products
BASIC INSTALLATION
AMPLIFIER FEET
The feet on the KSA can be used in several different ways. They are made from
machined Delrin and are supplied with separate threaded rubber bottoms.
The rubber bottoms can be screwed into the feet for protection of fragile
surfaces such as hardwood floors or furniture. For use on rugs, we
recommend using the feet without the rubber bottoms. KSA feet can also
accept the KRELL AMDs (Acoustic Mass Damper). The AMD is a type
spiked foot that threads into the bottom of the foot. These improve the
amplifier’s sonic performance in most installations and are particularly
effective on carpeted floors. Please contact your dealer or KRELL with any
questions.
REMOTE, MASTER/SLAVE CONNECTIONS - LINKING MULTIPLE
AMPLIFIERS
There are two Remote connectors on the back of the KSA labeled Master and
Slave provided for linking multiple amplifiers together. When the Master/
Slave cables are connected to each of the amplifiers involved, their meter
function controls and On/Off capabilities will be linked and controlled from
one amplifier.
Select the amplifier that you want to receive operation commands. That
amplifier will be the Master. Follow the instructions below for connecting the
amplifiers. Consider the Master receptacle the output and the Slave recep-
tacle the input.
1. Turn all of the amplifiers Offand unplug them from the AC wall receptacle.
Plug the amplifiers back in but do not turn them on before starting. This
ensures all amplifiers are synchronized when the cabling is connected.
Connect one end of the linking cable to the Master output on the back panel.
2. Connect the other end of the linking cable to the Slave Input on the second
amplifier.
3. To synchronize three amplifiers, connect a second linking cable to the
Master output on the second amplifier. Connect the remaining end to the
Slave input on the third amplifier.
PAGE 7