Filter
Top Products
CONNECTIONS
The pin assignment for the XLR is:
pin 1 = shield (ground)
pin 2 = non-inverting input (hot)
pin 3 = inverting input
NOTE: The RCA center conductor for each channel is wired in parallel with
pin 2, the non-inverted input. Only one of these inputs should be connected
to a preamplifier. Do not attempt to use the single-ended and balanced
inputs simultaneously.
3. Insert the AC power cord into the receptacle located on the back of the
KSA. Insert the other end into the wall AC receptacle. (Refer to the Basic
Installation section, for AC power requirements)
4. The amplifier is now ready for operation. Should you have any questions
regarding system set-up, contact your dealer or KRELL Industries.
PAGE 10