Filter
Top Products
D. BASIC INSTALLATION AND
OPERATION
1. Place the unit on a firm level surface free from exces-
sive dirt or moisture..The KRC-2 is not particularly hum
sensitive, therefore other components can be placed on or
around the KRC-2.
2. If you are using the separate. KPE ph.ono stage with the
KRC-2, the following connections apply:
NOTE: If you are not using the KPE proceed to step 3.
a. Unplug the KRC-2 from the wall AC receptacle.
b. Locate the 9 pin DC power connector labeled KPE
POWER.
c. Connect the KPE with the DC power cable supplie.d
with the phono stage, to the KPE POWER input on the
KRC-2.
d. Plug the KRC-2 into the wall AC .receptac.le..The Pilot
LED on the KPE should illuminate along with the
KRC-2. The input select will default to the mute po.sition.
Should the KPE pilot LED not illuminate, unplug the
KRC-2 from the wall AC receptacle and check aI1 qf your
connections. Should you have difficulty powering tlae
KR.C-2 and the KPE together please contact Krell for
assistance.
3. If you. are not using the .KPE,plug the AC cord into the
receptacle on the back of the umt. Plug the remaining end
into the .wall AC receptacle.The pilot LED will illumi-
nate, and the KRC-2 will default to the Mute position.
NOTE: While the KRC-2 has superb regulation and does
not require a dedicated AC circuit, we strongly advise
against any. connections through extension cords or mul-
tiple AC adaptors. High quality 15 amp line conditioners
or grounded AC strips are acceptable.
NOTE: The KRC-2 provides two special remote connec-
tors on the.backpane]. These are provided for future room
remote and remote slave formats. Please consult the
KRELL staff for assistance on these developments.