Filter
Top Products
Q. Why do I have. to turn up the volume so high to get
music at a normal listening level?
A. If your system does not seem .to have enough gain
over all, you are probab~ly not utilizing the balanced input
or output capabihties ot the KRC-2. For every balanced
termination on the KRC-2 yo.u increase the gain by 6dB.
If you still have to increase tlae gain too far, make sure
the KRC-2 is in the HIGH gain position.
~
. I came home one evening and the pilot LED in the
RC-2 was not illuminated. What stiould I do?
A. Unplug the KRC-2 from the wall AC receptacle and
check the. fuse in the rear panel. If there is a 15reak in toe
wire inside the fuse, replace it. If there is no break in the
fuse, do not try turning on the preamplifi.er or replacing
.the fuse. Call your dealer or KRELL. If tlae new fuse lets
thee unit turn on whenyouplug it in, then fails shortly
atterward, call KRELL Industries. If the fuse solves the
problem, carry on listening as usual.
Q. When I push the function buttons on the KRC-2 re-
mote control the preamp does not respond. What should I
do?
A. Check or change the batteries in the remote control.
The remote control will not operate the preamplifier in
other rooms not in the remote control’s trajectory..Make.
sure you have a direct path from the remote control to the
preamp front.
13