Filter
Top Products
Back Panel Description
See Figure 3 on page 11
12 Krell KAV–400xi
The KAV–400xi back panel provides connections for all inputs and
outputs, power on/off, and additional remote connections.
14 Left and Right Loudspeaker Outputs
The KAV–400xi is equipped with standard binding posts for each
amplifier channel. These connectors accept bare wire, pins, or
spade lugs. Use the red terminal for the positive connection and
the black terminal for the negative connection.
15 Left and Right Balanced Analog Inputs
The KAV–400xi is equipped with one pair of balanced (B-1) inputs
via XLR connectors.
16 Left and Right Single-Ended Analog Inputs
The KAV–400xi is equipped with three pairs of single-ended (S-1,
S-2, or S-3) inputs via RCA connectors.
17 Left and Right Tape Inputs
The KAV–400xi is equipped with a pair of single-ended tape inputs
via RCA connectors.
18 Left and Right Tape Outputs
The KAV–400xi is equipped with a pair of single-ended tape
outputs via RCA connectors.
19 Left and Right Preamp Outputs
The KAV–400xi is equipped with a pair of single-ended pre-
amplifier outputs.
20 RC-5 In
The KAV–400xi is equipped with an RC-5 input that makes cus-
tom installation easy and secure by accepting baseband RC-5
input commands from hardwired remote controllers.
21 12 VDC In/Out (12 V Trigger)
The 12 V Trigger allows you to turn the KAV–400xi on or off, or to
and from stand-by, from other components.
Out. The output sends 12 VDC (12 V trigger) power on/off signals
to other Krell components and other devices that incorporate a 12
V trigger.
AMPLIFIER CHANNEL
OUTPUTS
ANALOG INPUTS
ANALOG OUTPUTS
REMOTE
CONNECTIONS