Filter
Top Products
Front Panel / Remote Control Description
See Figures 1 and 2 on page 6
Krell KAV–400xi 7
Power, analog input selections, and volume control accessed via
the front panel of the KAV–400xi are described in the illustration
legend below. The front panel display shows volume and balance
levels, and Theater Throughput status. Most front panel features
can also be activated via the keys on the remote. Descriptions of
special operational features of the remote control are outlined on
pages 9-10:
1 Power Button or Key
Use this button to switch the KAV–400xi between the stand-by
and the operational modes.
2 Power LED
The blue power LED illuminates when the KAV–400xi is in the
operational mode. The power LED also flashes when any remote
control key is pressed.
3 Stand-by LED
The red stand-by LED illuminates when the KAV–400xi is plugged
into a standard AC wall receptacle, indicating that the amplifier is
in the stand-by mode and ready to be switched to the operational
mode.
4 Infrared Sensor
The infrared sensor receives commands from the KAV–400xi
remote control. For proper remote control operation, make sure
that nothing is obstructing the infrared sensor.
5 S-1, S-2, S-3, and B-1 Buttons, Keys, and LEDs
Use these buttons to select a balanced analog source component
(B-1) via an XLR connector or a single-ended analog source com-
ponent (S-1, S-2, or S-3) via single-ended RCA connectors. When
the button or key is selected, the LED illuminates.
6 Tape Button or Key
Use this button to playback pre-recorded tapes. You may also use
this button to compare the output signal of an analog tape recorder
to an audio source. See Tape Input and Output, on page 16.
7 Tape LED
The red tape monitor LED illuminates when the tape monitor is
activated. The LED does not illuminate when an audio source is
activated.
POWER
ANALOG
SOURCE
COMPONENTS