Filter
Top Products
Remote Control Description
See Figure 3 on page 11
12 Krell KAV–280p
The KAV–280p remote control uses one CR2025 lithium battery,
which is included with the shipment.
To open the battery compartment on the back of the remote
control:
1. Place the remote face down on the table.
2. Use your thumbnail or a small jeweler’s or eyeglass screw-
driver to move the small switch toward the center of the
remote, while using your index fingernail or screwdriver to pull
down gently on the slot to the right of the switch. The battery
compartment will slide out.
Do not use a knife or other sharp objects to open the battery compart-
ment; they will scratch the remote control finish.
3. Place the battery, positive side up, in the battery tray.
4. Slide battery compartment back into the remote until you hear
a click.
The remote control is ready for operation.
Replace battery when remote control function becomes intermittent.
Remove battery if the remote control is not used for a long period of time.
Battery leakage can damage the remote control.
The KAV–280p remote control accesses all preamplifier functions.
A description of the remote control keys that activate the
KAV–280p follows.
When you press a function key on the remote, the blue power LED (2) will
flash. (The LED will flash repeatedly if a key is held down.)
22 Pwr (Power) Key
Use this key to switch the KAV–280p between the stand-by and
the operational modes.
Note
Notes
Note
Battery
Installation
and
Removal
Remote Control
Functions
POWER