Filter
Top Products
18
Remote Control Description
See Figure 2 on the previous page
The Evolution 505 remote control provides the same functions as the front panel.
In addition, there are three keys that are unique to the remote control, and these
are described below.
22 Repeat Key
Replays selected track until new feature is selected. See also, Using the
Repeat Key,
on page 27.
23 Repeat A-B Key
Creates a loop between two pre-determined points within a single track or
sequential tracks. Press once to select the start of the repeat loop (A), and
press again to select the end of the loop (B). See also,
Using the Repeat A/B
Key,
on page 27.
24 Audio Key
Cycles between the stereo and multi-channel layers of an SACD disc.
The following remote control keys are not operational:
setup, disc, subt, angle, and ret.
Battery Installation and Removal
The remote control uses 2 AAA-size 1.5 Volt batteries. Batteries are included with
the shipment. To install the batteries:
1. Remove the remote control backplate, using the supplied T-10 Torx wrench.
2. Install the batteries, following the battery position diagram on the plastic battery
receptacle.
3. Replace and secure the backplate.
Note
Replace batteries when remote control function becomes intermittent.
Do not use a knife or other sharp object to remove the backplate, as this may damage the
remote control finish.
Remove batteries if the remote control is not used for a long period of time. Battery leakage
can damage the remote control.
(SECTION THREE: Anatomy of the Evolution 505 continued)