Filter
Top Products
8
9
Source Components to Ampli er
The Tiger accommodates just about any audio source. You can connect the
Tiger to personal portable CD, MiniDisc, or tape players, MP3 players, mini-
component and portable stereo systems, component CD and DVD players,
televisions, personal computers, game consoles, MIDI instruments and mod-
ules, mixing consoles, recording devices, and many other sources.
There are three sets of stereo inputs on the Tiger. The LINE input on the front
panel and the AUX input on the rear panel of the ampli er unit are recom-
mended for use with most consumer audio equipment. The AUDIO input on
the rear panel is better suited for source components that provide a high-level
signal, such as professional audio equipment with standard 0dBu (.775V) line-
level output or the ampli er or headphone outputs of some consumer audio
products.
If you nd that the sound is too loud with the AUX or LINE input, even at low
volume control settings, try using the AUDIO input.
Front Panel LINE Input
The Tiger ampli er unit features a convenient front-panel LINE input that
accommodates portable source components, such as MP3 players, that will be
frequently connected and disconnected from the system.
You can use either the two left/right phono jacks or the adjacent stereo mini-
jack to make the LINE connection. You can even have two di erent source
components connected to both the phono jacks and the mini-jack. Note,
however, that the phono jacks are disconnected when the mini-jack is in use.
Front Panel DC Output
Included on the front
LINE input panel of the
ampli er is a convenient
DC Output connector.
It is a standard USB
connector, as found on
personal computers, but its sole function is to supply DC power to portable
source devices, such as some MP3 music players. If you have a player that can
derive power from a USB connection, you can use this DC Output instead of
internal batteries or a separate AC adapter to power your device.
Do not attempt to power larger devices that require high current using the
Tiger’s DC Output.
AC Power Connection
After you have made all satellite, woofer, and input connections, plug the
female end of the supplied AC power cord into the matching connector on the
back panel of the Tiger woofer. Make sure the power switch/volume control
on the ampli er is in its OFF position (fully counterclockwise). Then, plug the
other end of the power cord into a wall outlet.
About Program Sources
Some sources, such as mini-component and portable stereo systems, have
no line-level outputs—only speaker outputs. If you plan to connect the Tiger
to such a high-level source, you should use the AUDIO input along with the
appropriate adapter cables. In some cases, with very high level ampli er
outputs, it will be necessary to use an adapter with an attenuator designed to
protect the Tiger’s input from overload. If you need such an adapter, please
consult an audio specialist.
If you have the choice between using low-level (“line”) outputs or higher level
(e.g., headphone) outputs on any source device, choose the former as they
will likely provide a cleaner, better-sounding signal. You can have all three sets
of inputs connected to di erent sources at the same time. You will be able to
switch among them using the Tiger’s input selector control.
Connections