Filter
Top Products
Page 12
This section describes the features found on the supplied remote control for your Palladium P-312W subwoofer.
The remote control works via infrared and, as such, will need a clear line of sight to the infrared receiver located
on the lower right quadrant of the front panel. The remote will work with or without the front-panel grille
installed. The codes from the remote can be programmed into any standard learning remote control if your
system includes such a device.
Volume + / -
These buttons adjust the level of the sub-
woofer up and down as described in the
“Volume” control section of this manual.
X-over + / -
These buttons adjust the frequency of the
lowpass lter up and down as described in
the “Lowpass” control section of this manual.
Phase + / -
These buttons adjust the phase control up
and down as described in the “Phase” control
section of this manual.
ARC On/O
This button toggles the ARC feature on and
o as described in the “Room Correction”
control section of this manual.
EQ Mode
These buttons provide direct access to any of
the three EQ modes as described in the “EQ
Mode” control section of this manual.
Presets
These buttons provide direct access to any of the ve presets as described in the “Recall Settings” and “Save Set-
tings” control sections of this manual.
Remote Control Operation