Filter
Top Products
18
EN
RADIO OPERATION
Tuning
1
Press the POWER / ON/STANDBY button to turn
the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the
desired frequency band. (FM ST, FM or AM)
4 Press the TUNING/TIME (%UP or fiDOWN) but-
ton to tune into the desired station.
Manual tuning :
Press the TUNING/TIME (%UP or fiDOWN) button
as many times as required to adjust the frequency
shown on the display to the frequency of the de-
sired station.
Auto tuning :
When the TUNING/TIME (%UP or fiDOWN) button
is pressed for more than 0.5 second, scanning will
start automatically and the tuner will stop at the
first receivable broadcast station.
Notes :
•
When radio interference occurs during auto scan
tuning, auto scan tuning may stop automatically
at that point.
• If a weak station signal is found during auto scan
tuning, the station will be skipped.
• To stop the auto tuning, press the TUNING/TIME
(%UP or fiDOWN) button again.
5 To receive an FM stereo transmission, press the
TUNER (BAND) button so that the “ST.” indica-
tor on the display lights up.
• “ ” will light up when an FM broadcast is in
stereo.
6 If the FM reception is weak, press the TUNER
(BAND) button so that the “ST.” indicator goes
off.
• The reception changes to mono, the sound be-
comes clearer.
After use :
Press the POWER / ON/STANDBY button to enter
the standby mode
Note :
•
The last station turned in will be recalled, even
after changing the tuning band or the function,
or after switching the unit to the standby mode.
4
1
2,3,
5,6
2,3,
5,6
4
1