Filter
Top Products
12
EN
To change the clock time :
1 Press the CLOCK button.
2 Within 5 seconds, press the MEMORY/SET but-
ton.
3 Perform steps
6 - 9 on page 11 .
To change the time display mode :
1 Perform steps 1 - 2 in the section “RESET-
TING THE MICROCOMPUTER”, on page 28.
2 Perform step
1 - 9 on page 11.
To see the time display :
Press the CLOCK button.
• The time display will appear for about 5 seconds.
Note :
• The clock display will flash on and off at the push
of the CLOCK button when the AC power sup-
ply is restored after a power failure occurs or
after the AC power cord is disconnected. If this
happens, follow the procedure below to change
the clock time.
SOUND CONTROL
Volume
(Main unit operation)
When the VOLUME CONTROL is turned clockwise,
the volume will increase. When it is turned anti-clock-
wise, the volume will decrease.
(Remote control operation)
Press the VOLUME up button (% ) to increase the
volume and the VOLUME down button (fi ) to de-
crease the volume.
Extra bass
When the power is first turned on, the unit will en-
ter the extra bass mode which emphasises the bass
frequencies, and “Ex. BASS” will light up.
To cancel the extra bass mode, press the EX. BASS/
DEMO (EX. BASS) button, and “Ex. BASS” will goes
off.
Pre-programmed equalizer
When the SOUND MODE button is pressed, the
current equalizer mode setting will be displayed. To
change to a different mode, press the SOUND
MODE button repeatedly.
FLAT : The sound is not modified.
ROCK : Bass and treble are emphasised.
POPS : Bass and treble are slightly emphasised.
JAZZ : Treble is cut a little.
CLASSIC : Treble is reduced a lot.
SAMBA : Treble is slightly emphasised.
FLAT ROCK POPS
SAMBA CLASSIC
JAZZ
Main unit Remote control
Main unit Remote control
Main unit Remote control
• When ROCK, POPS, JAZZ, CLASSIC or SAMBA
is selected, “EQ” will light up.