Filter
Top Products
XD-951/A900/A700 (En)
29
Preparation section Application section Knowledge sectionsBasic section
Selection of DOLBY NR (Noise Reduction)
To pause recording
Selection of the reverse mode
÷Pressing the key pauses recording after leaving a non-recorded space
of about 4 seconds.
÷If the key is pressed again in less than 4 seconds after it has been
pressed, recording resumes from that instant.
1Play (or tune) the input source to be
recorded.
2Start recording.
4. Select the source to be recorded.
5. Start recording.
÷When the CD input is selected and if a disc has
been set in the CD player, its playback starts
immediately.
The Dolby NR system minimizes the hiss noise heard when
playing tape. When playing a tape prerecorded with Dolby
NR ON, be sure to set the DOLBY NR ON for playback.
Lit when “DOLBY NR” is ON.
Each press switches the modes as follows.
1 “[”... Both sides are played back (recorded), and
then the tape stops.
2 “”” .. Both sides are played back endlessly.
(The tape stops after recording onto both
sides.)
3 ““” .. Only one side is played back (recorded),
and then the tape stops.
Each press switches the modes as follows.
1 “Ÿ NR” ON............... DOLBY NR is used.
2 “Ÿ NR” OFF ............. DOLBY NR is not used.
Let's record
Select an input source other than “TAPE”.
÷Recording stops automatically when the tape
side(s) to be recorded have been fully recorded.
The input source component to be recorded should be displayed.
Lights
REC/ARM
INPUT
44
NR
B
0
E
P
A
T
3
12
1
0
0
0
0
D
C
1TUNER (Radio)
2 CD
3 TAPE
4 AUX (External input)
(AUX INPUT LEVEL adjustment u)
DOLBY NR
REV.MODE
REC/ARM
55
3
12
1
0
1
2
0
D
C