Kenwood XD855 Stereo System User Manual


 
32
EN
Dubbing from tape to tape
1
Press the ON/STANDBY button to turn the
power on.
2 Load a prerecorded cassette into the TAPE A cas-
sette compartment. Insert a blank tape into the
TAPE B cassette compartment.
It is recommended that the recording tape be
the same length as the master tape.
3 Press the TAPE (A/B) button until “TAPE A” ap-
pears in the display.
4 Press the REC PAUSE button.
“REC.” and “¶ 3” will flash.
5 Press the 3 button.
“REC.” will disappear and “¶ 3” will light up on
the display.
To stop dubbing :
Press the 7 STOP button.
TAPE A and TAPE B will simultaneously stop.
Erasing recorded tapes
Make sure that TAPE A is not in use.
1 Load the tape to be erased into the TAPE B cas-
sette compartment.
2 Press the TAPE (A/B) button until “TAPE B” ap-
pears in the display.
3 Press the REC PAUSE button.
“ERASE” and “¶ 2 3” will flash.
4 Press the 2 or 3 button.
“ERASE” and “¶ 2 or ¶ 3” will light up on the
display.
1
5
3
4
2
7 STOP
2
3
4
1
Note :
When the end of the tape is reached whilst re-
cording, the CD player will display the track
number which was being played at that time,
and stop automatically.
If you want to restart recording from the begin-
ning of the interrupted track, turn over the tape,
press the REC PAUSE button and then the 3
button.
(If tracks have been stored in memory using the
program playback function, recording will restart
from the first track stored in memory.)
Selection of reverse mode :
Press the REVERSE MODE button repeatedly to
select the following setting :
” .....Recording stops after having recorded
both sides of tape.
” .....Recording stops after having recorded
one side of tape.