Filter
Top Products
27
EN
To recall stations that have been
stored in memory (PTY search)
You can search for desired stations by specifying
the programme type (see page 23 - 24) from among
the stations that have been stored in memory.
1 Press the POWER button to turn the power
on.
2 Press the TUNER (BAND) button to select the
FM ST or FM band.
3 Press the PTY button.
• “PTY TI” and “SELECT” will appear alternately
for about 6 seconds.
4 Within 6 seconds, press the P. CALL (4 1
or ¡ ¢) button to select the programme type
you want.
• Each time the button is pressed, the programme
type will appear. If the button is held down for
more than 0.5 second, the programme type will
appear continuously.
5 Whilst the selected programme type is flashing
(within 4 seconds), press the PTY button again.
• After the name of the selected programme type
has been lit for 2 seconds, “SEARCH” will ap-
pear, and the search operation will start.
Notes :
If the programme type has changed from flashing
to steadily lit and the PTY button is pressed, noth-
ing will happen. in this case, start again from step
3.
Each time a station of the programme type you want
is encountered, you will be able to listen to the
broadcast.
The channel number will flash for about 3
seconds.The station name will flash for 7 seconds,
and then remain lit.
• If you want to listen to another station of that
programme type, press the PTY button whilst
the channel number or station name is flashing.
The unit will look for the next station of that type.
• “NOT FOUND” will appear for 4 seconds, if the
requested programme type station is not found.
1
2
3,5
3
4
5
4